Once you have the material aligned you can continue stretching and fitting the cover around the seat.
Part Number, nEW Number, year/Model n/a 1997 sportster challenger (I believe this mpem installed IN first boats OFF THE line) n/a 1997 speedster n/a 1997 challenger n/a 1997 challenger n/a 1998 challenger / challenger n/a challenger 1800 / 1999 speedster n/a 1998 sportster / 2000.
I also have aftermarket mpems available for select older models.Put a staple at each corner or curve including the front of the seat (these staples may need to be removed later as you stretch the material into place).We are in no way affiliated with SeaDoo or Bombardier Inc.SBT's Cylinder Exchange Program gives you a complete top-end for your engine, ready to bolt.Pcinet, LLC, any reference to Original Equipment Manufacturer (OEM) names, trade names, specifications, or part numbers is for informational purposes only.One more note I dont have a parts book for the newer Jetboats that use the mercury motor, so if you need an mpem for one of those, I would have to call my supplier for the part number and availability.We do not suggest using a pressure washer since the pressure could be high enough to damage the material.Stainless Steel " staples to fit your gun.Industry, company, copyright 2017 National Appraisal saturn vue manual 2003 Guides, Inc., all rights reserved.BlackTip Jetsports Seat Cover Color Samples may view differently than actual color, depending on monitor settings.As long as the operator is careful, that shouldnt be a problem.
SBT Reman 2 Stroke Cylinder Exchange.
For bird droppings or other hard to clean spots, it may be necessary to use a scrub brush.
The individual section provides for a tight, custom fit and look.Installation of your new seat cover is easy and can be done by most do it yourselfers.I additionally offer a programming service for dess equipped boats.Small cracks can usually be repaired with duct tape to hide the damage.The cover is made from high quality marine vinyl and designed to last for years.Installation of the cover is easiest if the vinyl is warm, a nice sunny day, a warm shop, or a hair dryer can accomplish this.I additionally can install the replacement mpem in your electrical box if desired as well.National Appraisal Guides, Inc.Power and Associates 2017, all rights reserved.After the cover is completely stapled in place you should trim away any excess material.